# CDL General Knowledge practice test

15 free CDL General Knowledge questions from Clinched, each with the official source.

## 1. You slow gently for a red light in a truck with ABS. When does the ABS actually start working?
- A. Every time you press the brake pedal
- B. Whenever your speed drops below 5 mph
- C. When a wheel is about to lock from braking too hard

Answer: C. In normal braking, an ABS truck stops just like a truck without it. The system steps in only when hard braking is about to lock a wheel. It does not work on every brake application, and it is not triggered by a certain speed.
Source: CDL Manual (AAMVA model, March 2025), Section 2.18.8 Safety Reminders, “”

## 2. You are approaching a tight right turn in a tractor-trailer and will need to go very slowly to make it. How should you handle your speed?
- A. Begin braking early and slow down gradually
- B. Keep your speed up and swing wide into the turn
- C. Hold your speed and brake firmly near the corner

Answer: A. Most car drivers do not realize how slowly a big rig has to take a tight turn. Start braking early and lose speed gradually, which gives the drivers behind you time to react. Late, firm braking can surprise them, and carrying speed into a tight turn is unsafe.
Source: CDL Manual (AAMVA model, March 2025), Section 2.5.1 Signal Your Intentions, “”

## 3. This morning your loaded van trailer cleared a low overpass. You are now returning on the same road with the trailer empty. What should you do?
- A. Pass under it, since an empty van rides lower than a loaded one
- B. Recheck clearance, since an empty van rides higher than a loaded one
- C. Pass under it, since a van's height does not change with its load

Answer: B. A cargo van's height changes with its weight. An empty van sits higher than a loaded one, so clearing the overpass while loaded does not prove you can clear it when empty. If you are not sure you can make it, go slowly or take another route.
Source: CDL Manual (AAMVA model, March 2025), Section 2.7.4 Space Overhead, “”

## 4. Your truck carries reflective triangles as its warning devices for a stopped vehicle. How many must it carry at minimum?
- A. Six bidirectional reflective triangles
- B. Three bidirectional reflective triangles
- C. Two bidirectional reflective triangles

Answer: B. Federal rules require three bidirectional reflective triangles. Two is not enough. Six is the minimum number of fusees for a truck that uses fusees instead of triangles.
Source: 49 CFR §393.95 Emergency equipment on all power units., “(1) Three bidirectional emergency reflective triangles that conform to the requirements of Federal Motor Vehicle Safety Standard No. 125, § 571.125 of this title; or”

## 5. You drive in a type of commerce that requires a certified medical status on your driving record. Which document do you send to your state driver licensing agency to get that status?
- A. A current medical examiner's certificate
- B. Your employer's safety inspection report
- C. A copy of your recent logbook pages

Answer: A. Certified medical status is based on your current medical examiner's certificate, and you send it to the state licensing agency. Logbook pages are records of your hours of service, not proof that you are medically fit. An employer's inspection report covers vehicles, not the driver's health.
Source: CDL Manual (AAMVA model, March 2025), Section 1.2 Medical Documentation, “”

## 6. Which three things determine your blood alcohol concentration (BAC)?
- A. How much you drink, how fast, and your weight
- B. Which drink you choose, the hour, and your mood
- C. Your height, your age, and how tired you feel

Answer: A. Your BAC depends on the amount of alcohol you take in, how quickly you drink it, and how much you weigh. Choosing beer over liquor does not help, because standard servings carry the same alcohol. Mood, height and the time of day are not among the factors that set BAC.
Source: CDL Manual (AAMVA model, March 2025), Section 2.22.1 Alcohol and Driving, “”

## 7. During one shift you drove two different straight trucks for your company. What should you do with the after-trip inspection at the end of the day?
- A. Inspect both trucks and report problems so the carrier can schedule repairs
- B. Inspect only the truck you will drive tomorrow, and tell the next driver
- C. Inspect only the last truck, because it is the one parked at the yard

Answer: A. An after-trip inspection is done on every vehicle you operated during the trip, day or tour of duty. You may need to write up a vehicle condition report listing any defects. That report tells the motor carrier when a vehicle needs repairs. Checking only one truck leaves the other truck's defects unreported.
Source: CDL Manual (AAMVA model, March 2025), Section 2.1.2 Types of Vehicle Inspection, “”

## 8. You are pulled over while driving a placarded load, and you do not have a hazardous materials endorsement. What will happen?
- A. You get a warning and may finish the trip
- B. You are cited and not allowed to drive the truck
- C. Only your employer is cited, and you may continue

Answer: B. Driving a vehicle that needs placards without the hazardous materials endorsement is a crime. If you are stopped, you will get a citation and you will not be allowed to keep driving the truck. You are personally responsible, so a warning or a citation against only your employer is not the outcome.
Source: CDL Manual (AAMVA model, March 2025), Section 2.23.3 Lists of Regulated Products, “”

## 9. During which period do many heavy vehicle crashes happen?
- A. Between midnight and 6 a.m.
- B. Between 6 p.m. and midnight
- C. Between 6 a.m. and noon

Answer: A. Many heavy vehicle crashes happen between midnight and 6 a.m. These are hours when most people would normally be asleep. The morning and evening blocks are not the high-risk window named for fatigue.
Source: CDL Manual (AAMVA model, March 2025), Section 2.11.2 Driver Factors, “”

## 10. It is raining hard as the light turns green, and you are first in line in a loaded truck. How should you pull away?
- A. Give it full power in a higher starting gear
- B. Speed up quickly to get clear of the intersection
- C. Speed up very slowly so the drive wheels keep their grip

Answer: C. On slick pavement, adding power slowly helps the drive wheels keep their grip. Too much power can spin the drive wheels, and you could lose control. Rushing through the intersection or giving full throttle does exactly that.
Source: CDL Manual (AAMVA model, March 2025), Section 2.2.1 Accelerating, “”

## 11. You are taking a freeway exit that goes downhill and curves at the same time. When should you get your speed down?
- A. After you come out of the curve at the bottom
- B. Before you reach the curved part of the ramp
- C. While you are steering through the curve

Answer: B. A downhill exit makes it harder to slow down, and braking while you turn is dangerous. So you finish slowing before the ramp starts to curve. Braking in the curve combines braking and turning, and waiting until after the curve means you take it too fast.
Source: CDL Manual (AAMVA model, March 2025), Section 2.8.2 Hazardous Roads, “”

## 12. You see a "Maximum Safe Speed" sign at the top of a downgrade. How should you treat the speed shown on it?
- A. Follow it only when the road is wet or icy.
- B. Never go faster than the speed shown on the sign.
- C. Go up to 5 mph over it when your trailer is empty.

Answer: B. The speed on a posted limit or "Maximum Safe Speed" sign is a ceiling you must not go above. Your safe speed may be even lower depending on weight, the grade and the weather. Being empty or having a dry road does not give you permission to exceed it.
Source: CDL Manual (AAMVA model, March 2025), Section 2.16.1 Select a "Safe" Speed, “”

## 13. Your load of hazardous materials catches fire, and you are not sure which extinguisher is safe to use on it. What should you do?
- A. Wait for the firefighters to deal with it
- B. Use the A:B:C unit since it covers every class
- C. Use water since it works on most fires

Answer: A. When you don't know the right agent, and especially with hazardous materials, the safe choice is to leave the fire to trained firefighters. The wrong agent can make a fire worse. An A:B:C unit does not cover every class, such as metal fires, and water spreads fuel fires and conducts electricity.
Source: CDL Manual (AAMVA model, March 2025), Section 2.21.3 Fire Fighting, “”

## 14. You are traveling at 55 mph when glare blinds you for 2 seconds. About how far does your truck travel before you can see again?
- A. About the length of your own rig
- B. Over half the length of a football field
- C. Over two full football fields

Answer: B. At 55 mph, a truck covers more than half a football field in 2 seconds. That is well over 100 feet of road you cannot see. That is much farther than one rig length, but far short of two full fields.
Source: CDL Manual (AAMVA model, March 2025), Section 2.11.2 Driver Factors, “”

## 15. You are pulling a sealed van trailer, and the shipper has ordered you not to open it. How do the federal cargo inspection rules apply to the freight inside?
- A. You are not required to inspect the freight inside
- B. You must open it every 3 hours or 150 miles
- C. You must break the seal within the first 50 miles

Answer: A. The en-route cargo inspection rules do not apply to a sealed vehicle when you have been ordered not to open it. This exception also covers loads packed so that inspection is impractical. The 50-mile and 3-hour/150-mile checks are the normal rules, and they do not apply here.
Source: 49 CFR §392.9 Inspection of cargo, cargo securement devices and systems., “(4) The rules in this paragraph (b) do not apply to the driver of a sealed commercial motor vehicle who has been ordered not to open it to inspect its cargo”
